Harvey Hv3 Water - Softener Installation Manual Free ~upd~

: Connect using WRAS-approved flexible hoses, following the directional arrows on the manifold.

Drill and appropriate masonry/wood bits (for drain line routing) Bucket and towels to catch residual water Component Checklist

. Run this hose to a suitable drain or standpipe. The drain must not be submerged, and it must have an air gap to prevent back-siphonage. Step 5: Install the Overflow Pipe harvey hv3 water softener installation manual free

Slowly open the to the softener, allowing water to fill the twin tanks gradually.

Yes. During its regeneration cycle, the water softener backwashes the minerals it has collected out of the system and flushes them away. This requires a connection to a household waste pipe. : Connect using WRAS-approved flexible hoses, following the

The Harvey HV3 uses water pressure to flush out hardness ions during regeneration. The drain line must handle high-velocity discharge.

: Connect a 1/2” hose to the overflow spigot and run it downhill through an outside wall. Commissioning The drain must not be submerged, and it

You do not need to pay for a manual found on third-party "manual selling" sites. Use the official Harvey support channels to request the PDF directly—it is the safest way to ensure you have the correct revision for your specific HV3 model.

Standard 15mm kits are used for static head systems, while unvented or combi-boiler systems may require 22mm high-flow hoses.

1.0 bar (14.5 psi) required to actuate the internal control valve.

To help you finish setting up or managing your water softener, let me know: What is your household's average ? What is the measured water hardness level in your area?