Lenel Lnl-3300-m5 Installation Manual Upd

Connect to the negative downstream communication line.

Shut off the AC mains feeding the Micro/5 enclosure and disconnect the backup battery before removing or inserting hardware. Mounting and Hardware Setup

Features onboard 10/100 MB Ethernet for fast communication with the OnGuard server.

The M5 series serves as a bridge between older hardware and modern IP-based security management. By utilizing the existing footprint and wiring of CASI Micro/5 enclosures, the LNL-3300-M5 reduces labor costs and system downtime during upgrades. Key Features: Compatibility with OnGuard version 6.4.500 or higher. Support for up to 16 downstream device addresses. Onboard 10/100 Ethernet port for primary communication. Lenel Lnl-3300-m5 Installation Manual UPD

For detailed wiring diagrams and dip switch settings, technical personnel typically refer to the full Lenel M Series Installation Guide available through authorized LenelS2 partners .

While the LNL-3300-M5 can be configured through its embedded web server, some settings for downstream modules are managed via DIP switches. For example, the LNL-1320-2RP Reader Module uses on-board DIP switches to set its device address and baud rate.

For downstream controller enclosures that use the LNL-8000-MCOM interface module (which lacks these dedicated inputs), you have three wiring options: wire switches in series, connect them to available inputs on an LNL-1100-20DI board, or connect them to available reader port inputs on a reader interface module. Connect to the negative downstream communication line

Align the LNL-3300-M5 with the existing Micro5 footprint standoffs. Secure the board using the provided non-conductive screws. Ensure the grounding strap connects to the chassis ground. 2. Wiring the Power Supply Use 18 AWG twisted-pair wiring for the main power input. Connect the positive wire to the terminal. Connect the negative wire to the GND terminal. Do not apply power until all peripheral wiring is complete. 3. Network and Serial Connections

Whether you are using a for this panel

Align the LNL-3300-M5 board with the standard Micro/5 chassis mounting studs. The M5 series serves as a bridge between

Save the panel configuration. Right-click the newly created panel in the communication status monitor and select Download (ensure you check options for "Cardholders", "Operating System", and "Database"). 5. Troubleshooting and Diagnostic LEDs

Assign a static IP address, Subnet Mask, and Default Gateway matching your corporate security network.