Jungheinrich Etv - 216 Error Codes

The error code returns immediately after a hard battery reset.

Inspect the sensor track along the mast. Clean any grease, dirt, or dust buildup off the sensors. Ensure the physical targets or magnets line up perfectly as the mast raises and lowers. Steering and Control Errors (3000 Series) Error Code 3004: Steering Angle Sensor Mismatch

The following codes are frequently encountered on the ETV 216 and related series: jungheinrich etv 216 error codes

Lower the forks to the ground, apply the parking brake, and turn the truck off.

Component failures (e.g., motor, controller). The error code returns immediately after a hard

Swapping the same part from another reach truck worked without issues, but the new part triggered the error. The explanation revealed that both parts had the same number but different software — one configured for drive/braking, the other for hydraulics. Another technician described: "At unit start up, blank screen then error 0802. Measured all coils, all within 15-30ohms range. ... Found cracked sensor on outer LS of mast. Found open 9f2 slot (7.5a / 58v) fuse".

Remember: when in doubt, consult your service manual or contact Jungheinrich support with your truck's serial number ready — the right information saves time, money, and frustration. Ensure the physical targets or magnets line up

The traction motor has exceeded its safe operating temperature.

Drive pedal activated while the parking brake is still engaged.

The steering motor is drawing too much electrical current, indicating heavy mechanical resistance.