Bonavita Hudson Ii Lifestyle Crib Instructions

Assemble the crib directly in the nursery. Fully built cribs rarely fit through standard bedroom doorways. Clean the floor and lay down a large blanket or the cardboard packaging to prevent scratching the wood finish.

Insert barrel nuts into the predrilled holes in the stabilizer bar. Secure the bar to the side rails using 3 1/8-inch bolts and washers.

Lay the headboard and footboard face down on your protected work surface. Insert the large wooden dowels into the pre-drilled holes on the inner sides of both boards.

Insert barrel nuts into the predrilled holes of the stabilizer bars. Align them to capture the bolts. Connect Headboard and Sides: bonavita hudson ii lifestyle crib instructions

Whether you mislaid your original manual during a recent move or bought this beautiful crib secondhand, finding accurate, step-by-step guidance is essential for your child's safety. This comprehensive article serves as your ultimate guide to the assembly, conversion, and safety maintenance of the Bonavita Hudson II. 1. Safety First: Pre-Assembly Check

Prethread the bolts into the footboard's bottom legs. Insert the remaining 2-inch Allen bolts through the crib's sides and into the footboard, tightening them securely. Conversion Guide

Stand the headboard/rails assembly upright. With your helper supporting the front side, attach the footboard to the open ends of the two side rails using the same bolt pattern. Assemble the crib directly in the nursery

Attach the opposite ends of the bed rails to the front footboard panel.

The Hudson II converts to a toddler bed by removing the front rail and replacing it with a safety rail.

Lay out all wooden panels and hardware packs. Check them against the lists below to ensure nothing is missing before you begin. Insert barrel nuts into the predrilled holes in

Start by identifying the and Left Front Leg . Attach them to the headboard or side panels using the provided Allen head bolts and barrel nuts. Insert a barrel nut into the pre-drilled hole in the panel, then thread the bolt through the leg and into the nut. Repeat this for the right side. 2. Install the Stabilizer Bar

Select your desired mattress height. For newborns, use the highest setting to easily reach your baby. As soon as your child can sit up independently, you must lower the mattress to the lowest setting to prevent falls.

If storing the crib between children, disassemble it completely, wrap the wooden panels in moving blankets, and place all hardware into a labeled, sealed plastic bag taped securely to one of the main panels.

Repeat the process used in Step 1: insert barrel nuts into the front panel, align, and insert the long bolts through the side panels to secure the front gate. Step 3: Mount the Mattress Support Spring