Periodic maintenance is essential to ensure long‑term reliability and to prevent unexpected downtime.
Route the AC mains cable into the designated power terminal block inside the master cabinet.
Anchors must reach a minimum depth of 70mm into the concrete.
Use a laser level or string line to ensure all cabinets are perfectly parallel and aligned along the front edge. Misalignment will cause optical sensor faults. 4. Mechanical Anchoring and Leveling
Walk into the lane from Direction B without an authorization while the lane is idle. The barrier must remain closed, and a loud acoustic alarm should trigger. gunnebo speedstile fl installation manual
: Minimum dimensions of 2000mm x 500mm x 150mm deep are recommended. Cabling & Conduits :
Check the status LEDs on the optical sensor array. All infrared beams should show a "Clear" status when the lane is unobstructed.
The of your SpeedStile FL (e.g., FL EV, FL sbe)?
The SpeedStile will perform a self-diagnostic routine. The glass wings will move slowly to find their open and closed limit switches, then lock in the closed position. Use a laser level or string line to
Test the opening and closing mechanism to ensure the wings function smoothly.
Connect the open-collector or dry-contact outputs from your access control panel to the Volg_L (Left Passage) and Volg_R (Right Passage) terminals.
Mount the glass wing onto the heavy-duty rotor clamp assembly.
, thorough preparation is required to prevent delays and structural issues. Mechanical Anchoring and Leveling Walk into the lane
The manual mandates a rigorous site survey:
Status display turns green; glass wings open smoothly in the direction of travel; gate closes immediately after passage.
The Gunnebo SpeedStile FL is not a temperamental device. It’s . If you rush, it will humiliate you with false alarms. If you’re methodical, it will move 60 people per minute without breaking eye contact.