The one place to find the hottest news from the page.
* Installation Guide
* Tools Guide
* Contributors
* FAQ
and more good things to know
The heart of the page! Be sure to say hello!
What is done, or still needs to be done?
This is were we show off our models
And here the fun starts!
Other cool sites!

Everstart Battery Charger 60108m Manual

The 100A setting is designed for short bursts of cranking power, not continuous charging. Connect the clamps and set the dial to . Plug the charger into the AC outlet. Crank the engine for no more than 3 to 5 seconds .

The is a multi-functional 12V automotive tool equipped with a 2-minute engine start aid, smart charging microprocessor, and an interactive LCD display . This portable, high-density charging station automatically detects battery chemistry, adjusting output across trickle, quick, and rapid charge cycles. Proper operational and safety knowledge is critical to optimizing performance and preventing property damage or injury. Technical Specifications Configuration Specification Model Number Input Voltage 110V–120V AC, 60Hz Output Voltage Amperage Modes 2A (Trickle), 10A (Quick), 25A (Rapid) Start Aid Duration 2 Minutes (120-second countdown) Battery Compatibility Standard Lead-Acid, Gelatin, AGM Safety Certifications FCC, cULus Listed Unit Weight 3.62 lbs (1.64 kg) Essential Safety Precautions

Ensure the wall outlet has power by plugging in another appliance. everstart battery charger 60108m manual

You have two scenarios: the battery is installed in a vehicle, or it is removed.

: Never operate the charger in a completely closed area. Ensure adequate airflow around the battery. The 100A setting is designed for short bursts

Attach the (positive/+) clamp to the positive terminal of the battery.

If you encounter problems with your EverStart 60108M charger, the table below can help you identify and resolve them. Crank the engine for no more than 3 to 5 seconds

: Slide the battery into the spring-loaded holder until the pins make firm contact with the terminals. The holder will lock the battery in place.

Never smoke, strike a match, or cause a spark near the battery or engine.

| Problem | Possible Solution | | :--- | :--- | | | • Ensure all connections are secure. • Check that the AC outlet is functioning. • If the battery voltage is below 2 Volts, this charger cannot revive it. | | LCD shows 'Reverse Polarity' error | • The clamps are connected backwards. Immediately disconnect and swap the clamps. An audible beep will likely sound. | | Engine will not start | • Ensure the battery clamps are making a good, clean connection. • The battery may be too severely depleted for the Start Aid function to work. Try charging at 10A or 25A for 10-15 minutes before attempting Start Aid again. | | Charger feels hot | • It's normal for a charger to generate some heat. However, if it's too hot to touch, unplug it and let it cool. Ensure it's in a well-ventilated area and not covered. | | Display shows an error icon | • Consult the manufacturer's manual for the specific error code. Many errors relate to battery issues (e.g., a shorted cell). |