Gmr-32b Phase - Controller Manual

Position the unit inside an enclosed electrical distribution box or power distribution cabinet away from direct water contact or corrosive environments.

Evaluates amplitude deviations. If line voltages breach pre-configured upper limits (surges) or lower limits (brownouts), the internal relay trips to safely isolate sensitive control logic.

Two Normally Open (NO) + Two Normally Closed (NC), electrically inseparable 250VAC @ 6A / 30VDC @ 3A Conventional Heating Current Power Consumption ≤is less than or equal to Dimensions 79 x 23 x 79 mm (3.11 x 0.91 x 3.11 inches) Mounting Capability Dual M4 screw holes (direct) or 35mm HT35 DIN rail Environmental Limits

Ensures that the sequence of incoming lines matches the specified clockwise rotation ( gmr-32b phase controller manual

Power side of three-phase network (Do not install on VFD output)

Monitoring overall line health before branching power to sub-systems.

250VAC at 6A (inductive AC-15 load) / 30VDC at 3A (direct current DC-13 load) 8A continuous carrying limit Maximum Power Consumption ≤ 10VA internal power draw under full inductive load Conductor Wiring Requirements Position the unit inside an enclosed electrical distribution

Adjust the trimmer until the desired peak output voltage is achieved. 6. Diagnostic LEDs and Troubleshooting

380VAC nominal (compatible with 220V, 440V, and 460V industrial subsystems) Dual-rated for 50Hz and 60Hz power distribution grids Physical Dimensions 79 mm × 23 mm × 79 mm (3.11 in × 0.91 in × 3.11 in) Relay Contact Assembly

Slowly increase the control signal from your PLC or potentiometer and observe the load current to ensure smooth modulation. 7. Troubleshooting and Error Codes Two Normally Open (NO) + Two Normally Closed

⚡ High voltage equipment poses significant risks if handled improperly.

| Symptom | Probable Cause | Corrective Action | | :--- | :--- | :--- | | | No power supply / Internal Fuse blown. | Check L1/L2/L3 input connections; check internal fuse. | | Red LED Lit (Phase Loss) | Broken wire or blown upstream fuse. | Use multimeter to verify voltage on all three input terminals. | | Red LED Lit (Phase Seq) | L1, L2, L3 connected in wrong order. | Swap any two incoming power lines (e.g., swap L1 and L2) at the input terminal. | | Intermittent Tripping | Loose connection or Hysteresis set too low. | Tighten terminal screws; Increase Ud (Unbalance) threshold slightly. | | Relay Not Switching | External load exceeds relay rating. | Verify load current is < 3A; check for short circuit in external control wiring. |

– If you know where it was purchased, they may have a PDF.

Protecting massive scroll compressors from reverse rotation.