Atir Strap And Beamd With =link= Crack New Jun 2026

If the interior column settles differently than the exterior column, the strap beam is subjected to bending moments it wasn't designed to handle, leading to cracking.

Incorrect calculation of expected loads, leading to under-designed beam dimensions or insufficient rebar/stirrup spacing.

Once the analysis is complete, the results are exported to BEAMD for physical implementation:

A beam repaired with ATIR straps after a should be inspected at: atir strap and beamd with crack new

Clean the crack using a wire brush to remove loose debris, dirt, and laitance. Blow out the deep crevices using oil-free compressed air.

High-strength carbon fiber sheets are bonded to the exterior of the beam using epoxy. This acts as external "stirrups" and significantly boosts shear and flexural strength without adding bulk.

—but it held. The strap acted as a surgical brace, keeping the wound from opening further. If the interior column settles differently than the

Rapid water evaporation during curing or premature removal of formwork.

: Request an immediate forensic engineering inspection. Step-by-Step Repair Protocol for New Concrete Beams

: Diagonal cracks or cracks accompanied by displacement (one side of the crack is higher than the other). Blow out the deep crevices using oil-free compressed air

Vertical cracks starting at the bottom edge of the beam and moving upward near the center of the span.

While STRAP provides the overall structural analysis, is the specialized tool dedicated to reinforced concrete beam design, detailing, drafting, and scheduling. The software description calls it “the complete and totally integrated solution for RC beam design” that “transforms a tedious and error‑prone task into a fast, efficient and enjoyable interactive design experience” .

ATIR STRAP and BEAMD together form a modern, integrated solution for structural engineers who must confront the reality of cracked concrete beams. By combining finite element analysis with code‑compliant crack width calculations and automated reinforcement detailing, this software eliminates the gap between idealized perfect models and real‑world behavior.

: You can export analytical models from STRAP or AutoSTRAP directly into BEAMD for 2D beam analysis, detailing, and scheduling.

When designing an ATIR strap repair for a , the following formulas apply: